Basic HTML Version
AQUA–STAR EXPLORER 65’
Aqua‐Star, Ocean Yard, Bulwer Avenue, St. Sampsons, Guernsey, Channel Islands, GY2 4LE
The craft is a standard 65’ Twin Screw Motor
Yacht build on the Aqua-Star 65’ hull and su-
perstructure mouldings to the following specifi-
cation.
A Glass reinforced plastic moulding con-
structed to Lloyds Register of Shipping recom-
mendations and a modern Lloyds approved
moulding factory using the latest Isophthalic
gelcoat, woven cloth reinforcing, Balsa cored
topsides for extra stiffness and insulation.
Stringers, water tanks, main bulkheads and
engine settings are moulded to the hull, with
water tight bulkheads. Colour Royal Yacht
Blue or White.
Bulwark surrounding Decks
Windlass with 300’ Chain & 75llb Anchor
Stainless Steel Anchor Mount
Windshield System Tempered Safety
Glass
Stainless Steel Bow Rail
Bow, Spring & Stern Cleats
Bulwark Fairleads
Walk around Side Decks
Fuel Fills Port & Starboard with Locks
Water Fills Port & Starboard with Locks
Holding Tank Pump Out Fitting
Stainless Steel Hand Rails
Foredeck Wash down Fresh & Sea Wa-
ter
Sunpad Cushion with Drinks Holder
Fender Locker on Foredeck
GENERAL
HULL
MAIN DECK
Aqua-Star Design 2007
Styled by Aqua-Star and Ken Freivokh
Interiors.
Approximate Length Overall
65’
Approximate Length Waterline
52’
Approximate Beam
19’3”
Approximate Draft
5’
A GRP moulding constructed to Lloyds
Register of Shipping recommendations
and bonded to hull, colour white. Balsa
and ply reinforced for insulation and stiff-
ness.
Stainless Steel Framed Sliding Door
to Saloon
Access to Storage Locker (Gas if on
board)
Fender Locker
Upholstered Lounge Area with Table
and Seating
Stainless Steel Handrail with Steps
to Flybridge
Capstans Port with Foot Switches
and built in Roller Fairleads
Shore Power Cord Starboard
Courtesy Lighting
Halogen Lighting
Fresh Water Wash down
Dock Side Water Inlet
Teak Laid
DESIGNERS
DIMENSIONS
MAIN DECK AND
SUPERSTRUCTURE
AFT DECK